A, UV equipment for use

  Usage:

 1. To supply the correct access to power lines.

 2.合always button switch, power LED, press the power button to start, the machine is in standby mode.

 3. Closed electric switch, mesh belt running, please adjust speed according to product requirements knob, so that network with appropriate speed.

 4. Start A light, A lamp current to be reduced to a stable state after the start B or C lamp lights. In order to prevent over-current power switches.

 5. Closure of UV lamps, press A to stop lights, B button lights stopped fan continuous operation, the ultraviolet lamp for heat, cooling tubes to be automatically cut off power supply switchboard.

 6. The power to start after the long period of time does not turn on the lights, equipment will be automatically cut off power supply switchboard.

 7.'s Lights are turned off immediately after the start of UV lamps, light is not a normal phenomenon when the UV lamp lit before cooling.

 8.拆换UV lamp, the open on me after the song off the power cord Lightbox fastening screws, pulled out for拆换Lightbox.

 Second, pay attention to matters:

 1. Grounding line is well grounded.

 2. Blower not normal, not to use so as to avoid burning UV lamp.

 3.拆换UV lamp, do not touch the lamp with his hands to prevent the UV lamp caused mole, the impact of light-emitting efficiency, must wear clean gloves to install.

 4. Shut down immediately after the UV lamp restart, ultraviolet light does not shine is a normal phenomenon when the UV lamp can be re-lit after cooling.

 5. In order to prevent premature aging UV lamps, lights can not immediately switch to cut off power supply to be cut off the machine automatically shut down after a total power supply.

 6. When the drive roller in the process of turning a slight beating, please timely transmission roller screw tightened at both ends of the close.

 7. When a serious failure of the machine, please promptly notify the manufacturer or distributor, do not open the case on its own.

 Third, UV equipment failures day-to-day approach to the possible causes and the reasons for failure may approach

  1 UV light does not shine or self-extinguishing

  1. UV lamp UV lamp replacement of aging

  2. Not enough to clear the air duct to clear the debris fan Clinopodium

  3. Supply voltage lower than the 10 percent raise voltage less than 2 UV lamp brightness UV lamp UV lamp replacement of aging

  3 transformer high temperature (> 95 ℃) 1. Supply voltage higher than 10% lower input voltage machines, enhanced ventilation

  2. Machines around poor ventilation machine to clear the surrounding environment clean-up

  4 UV light after the closure of all the equipment can not automatically shutdown delayed the replacement of damage

  5 deviation net mesh belt with elastic around the uneven re-mesh belt adjustment screws

  6 roller bearings different sound to replace damaged