Preheat time, the summer temperatures are high, the warm-up time is short; winter temperature is low, preheat the hours are long, warm-up time to 2-3 minutes. If the machine has the strength of UV-ray devices, should be in the starting stalls bright lights, it can shorten the lamp warm-up time, if the production needs of low-light, can be preheated to poor light after the end of file.

 Second, the maintenance of lamp (1) UV lamp life is generally the biggest 800-1000 hours to life should be replaced immediately.

 (2) UV lamp use during the period, at an appropriate time (1-2 months) with anhydrous ethanol, a clean gauze mask tube surface and reflective surface sounding board, and then UV lamp rotating 180oC. Lampshade sounding board after losing mirror effect should be replaced.

 Third, the speed of adjustment

 (1) the best speed options: the first products to speed the adoption of a UV-curing device, if the curing, and then faster, until the adoption of curing device products just can not be completely solidified until, when the speed multiplied by 0.8 is the most good speed.

 (2) In addition we must pay attention to the use of UV lamps time, with the UV lamp to extend the use of time, energy will be attenuated, will adjust their speed to slow.

 Fourth, transformers, capacitors

 (1) transformer into line voltage according to the scene to choose a suitable post.

 (2) capacitor in the use, maintenance must be carried out if the discharge, so as to avoid wounding capacitance discharge.

 V. UV will damage the eyes and skin, please do not turn on the lights when the tube surface with your eyes open at the same time not to let the ultraviolet radiation skin.