1. Network with the operation of routes must be spacious, no prominence and exposed sharp edge, the channel surface must be smooth hairless assassination, no oil pollution. Support network with the various components must be flexible operation, there shall be no stagnant phenomena between roller and roller must be parallel.

 2. Driven drum diameter requires more than 120mm, the outer surface of rubber-coated proposals to improve the driving capability. In the run-time network with the bending direction of the recommendations for a single direction, two-way will be to shorten the life of bending.

 3. Not free to network with twists and turns, which will enable broken glass, installation can not be forcibly pulled mesh belt, which will result in the breakdown of mesh belt.

 4. When the network with good connections, the careful adjustment of tension in order to be able to drive the machine with your network, rather than make adjustments to the net to bring the feeling of tension. Tension have been forced to have a deviation would mesh belt, joint fracture, including a series of destructive side of fracture can be damaged.

 5. Preheating machine: When the network with soft after running, and then carefully fine-tuned to maintain the network tension with non-deviation, and in the case of normal load operation, and then run two hours of aging.

 6. Shutdown when debugging the first time, you must first turn off the heat source, and then maintain a network with the continued operation of 10 minutes after the shutdown.